ep

January 4, 2021

1.A connecting website link of an O-ring Chain for general application is pre-coated with grease at the pins. Before connection, confirm the grease about the surfaces of pins, and if your volume of grease is modest, apply grease with bare hands. (If gloves are applied, the grease might be absorbed by the gloves.)
Example: When the connecting link (I) of an O-ring chain for basic application is
shipped, O-rings are fitted with the roots on the pins. In the event the O-rings come loose due to vibration during transport, refit the O-rings in for the roots of your pins.
In this case, make sure you return the grease collected in the roots of your pins towards the central surfaces with the pins, additional at portion A than at portions B shown inside the over illustration. (Portions A is worn because of sliding with all the bushings.)
2.The chain might be most conveniently connected over the teeth of a sprocket. Engage the links at each ends of the chain with all the sprocket teeth and fit connecting pins. In the event the sprocket might be moved, the chain can also be linked on the loosened side.
3. Connecting process
1.Verify that O-rings are attached to the roots on the pins.
two.When the quantity of grease utilized over the connecting pins is smaller, coat the pins with grease in the central portions.
3.Insert the connecting pins into the bushings from the inner hyperlinks at the two ends.
4.Confirm the grease is applied to the whole face from the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and when pressing the connecting plate, set up the spring clip. Confirm whether the head (the end without a split) of the spring clip is turned inside the feeding route from the chain. (See the following illustration.)
6.Be sure to verify the spring clip is securely fitted during the clip grooves in the connecting pins.
This completes jointing of your connecting hyperlink. Note that grease over the surfaces of connecting pins and O-rings may be eliminated throughout installation work. In this case, re-grease making use of the grease over the surface on the base chain or even the grease during the polyethylene bag through which the connecting website link was contained.